Pull, Snap, Pile!

Pull, Snap, Pile!

©GBNNSS

It may look pretty but once established Himalayan balsam can do substantial damage to our riverbanks and the species that depend upon them. You can help stop the introduction and spread of this invasive non-native species. Just use our simple guide below:


Himalayan balsam seeds

© NWWT

Before: Make sure it hasn’t gone to seed. Pulling at this point will only help spread seeds further.

Severn Trent Balsam Bash

© NWWT

Pull the roots out of the ground by holding the stem as close to the ground as possible so it doesn’t snap. A Himalayan balsam plant can regrow if the roots are still in the ground!

Balsam root

© RPS Group Plc

Snap the stem as close to the root as possible, making sure it’s below the first node (knee like joints where the leaves grow out of).

Balsam bounce

© Lesley James

Once the plant has been snapped, place them in a pile and leave them to rot. 

Check Clean Dry

After: Make sure if you are walking anywhere where there are invasive non-native species you are checking your shoes, clothing and equipment for any plant parts, cleaning everything down before you go home, and drying everything out before using it again.

Want to do more? The Wales Resilient Ecological Network Project is always looking for volunteers to assist our dedicated team.  For more information, visit

www.northwaleswildlifetrust.org.uk/waren

Himalayan balsam in flower

© NWWT

Himalayan balsam

Species information